Their advantages
- Vacuum filter for low volume flows
- Correct separation of dirt/clean side
- Low fleece usage
- Compact design
The POLO inclined bed filter SBV cleans many different liquids fully automatically.
The well-known advantages of the POLO SB series have been completely incorporated here and expanded by vacuum technology. This combines the compact design with a high throughput capacity.
The dirty liquid flows into the dirt chamber of the filter through an inlet distributor that avoids turbulence. The exhauster draws air and thus liquid through the fleece into the clean chamber of the filter, thus creating a negative pressure. This negative pressure increases the flow rate, allows the filter cake to build up higher and, as air is drawn through this filter cake, produces a dry stab-proof discharge. The higher-building filter cake provides a high-quality filter layer that improves the degree of purity.
The filter discharge pump directs the cleaned liquid into a clean tank. At a maximum level in the dirt chamber, a fleece pre-stroke is triggered. At the same time, the used fleece is conveyed into the dirt container and a fresh fleece is drawn in. The filtering process does not have to be interrupted for this operation; no buffer tank is necessary.
Due to the short fleece pre-strokes, only a very small part of the filter surface is renewed, so that the built-up filter cake remains largely intact as a “precoat” thus increasing the filter fineness.
A hose seal, resistant to all commercially available cooling lubricants, reliably isolates the dirt chamber from the clean side.
A fleece shortage switch signals that the fleece roll needs to be replaced.
Precise sealing
Lightweight fleece usable
Made in Germany
Variety of materials
Process safety
Picture gallery
Data sheet
Standard sizes | SBV-B1.4 | SBV-B1.9 |
---|---|---|
Mounting dimesion L x W | 1450 x 1110 | 1950 x 1110 |
Lenght | 2150 | 2650 |
Width | 1460 | 1460 |
Height | 1550 | 1550 |
Weight approx. (kg) | 1000 | 1100 |
Dirt chamber content approx. (litres) | 400 | 650 |
Vacuum chamber content approx. (litres) | 140 | 230 |
Flow rate max. (l/min) emulsions* | 700 | 950 |
Flow rate max. (l/min) oils* | 350 | 475 |
Connected load (kW) | 3,88 | 3,88 |
Supply voltage | 3 ~ 400 V 50 Hz | 3 ~ 400 V 50 Hz |
*Definition of flow rate: Emulsions and aqueous media approx. 1 mm²/sec at 20 °C and oils up to 15 mm²/sec at 20 °C.
The maximum flow rate of the filter is indicated; depending on the machining process and the degree of contamination, the flow rate may be lower.
Subject to technical changes in the interest of progress.